CAN communication between 2 stm32f0 boards

Hi My name is Jean Paul and I have extensive experience working with CAN and STM32. I am very knowledgeable by using CAN with standard/extended IDs at different speeds 500 Kbps/1Mbps. Also I used HAL or native libraries to configure the CAN driver. Let's discuss.

i have already experience in CAN communication with stm32 series . so ic an do your job within a time limit with your satisfaction.

Hello! Nice to meet you! I have read your project carefully. I am very interested in your project. I am a Microelectronics and Automation engineering expert. I have a lot of experience on ARM, FPGA, DSP, Arduino, Raspberry, PLC, PIC, ATMega and so on. And I can code the Python, C/C++, C#, Mobile App. I can do help you. I hope to cooperate with you. Tell me your opinion. My regards.

hi, I am embedded software developer with 9years of experience majorly in automotive systems like airbags and engine control systems. I have worked on CAN protocol and it's various controllers for 6 years and stm32 for 7 years. I have even published an IEEE paper on application of CAN protocol in solar powered homes. I also have the required tools and hardware with me which are same as your hardware setup. Although I am new to freelancer portal, I have did many freelance projects in offline mode for various start-ups. I feel I would be right candidate not just because I have the right skills but also would like to know more about your application/product in present and near future. Let me know if you would like to discuss more. regards, Raj

Here is my proposal: 1) I will use Cube MX to configure your project which is good to go for maintainability 2) I will configure 500kb as baud rate CAN buffer with transmit complete intr and receive intr 3) You must use MCP2551 CAN trans receiver buffer 4) Put 120ohm both side termination 5) I have used 31 devices in CAN network with STM32F105 series and its is mass production 6) I have hands-on experience and would help you out for this project. PM me for more details you want. 7) have good day

Hi, I have extensive experience on STM32 controllers. And also have drivers for CAN for stm32f0 series. I can have a communication portal up and running between a master and slave on CAN bus within a day or two. Please get in touch to discuss more details. P.S : Please have a look at my profile and portfolio for more background on my work. Regards, Nasreen Shaikh Thane, Maharashtra

Dear project owner. I'm a senior software engineer. I have over 8 years experience in web development and over 10 years experience in embedded system development. I can help you to make this CAN communication work. I have the CAN device for Rasppi or Arduino here. I can work and fully understand about CAN protocol. Please consider my bid and I hope you want to talk more detail about this project over chat. Regards, Teguh

Stm32 discovery board and Stm32f103c8 controller i have worked with using STM CubeMx. i am quite experience to perform this project kindly share more info.

hello sir I am Ajay Soni,embedded system developer. I have worked on can protocol. I have also used stm32 series mcu for can protocol developer. I have 3 years experience in stm32 programming.

.....

Hi I have working experience of 5 years on CAN communication