Connect sensor to NodeMCU and send data to RaspberryPi /SignalK server.

This project contains 2 Parts. Part 1: Programming of NodeMCU Part 2: Receive date on RaspberryPI / SignalK Used Material: AZDelivery NodeMCU Lua Lolin V3 WiFi Parent https://www.amazon.de/gp/product/B074Q2WM1Y/ref=ppx_yo_dt_b_asin_title_o01_s00?ie=UTF8&psc=1 Following Sensor shall be connected to the NodeMCU: https://www.amazon.de/gp/product/B07YZGBVLM/ref=ppx_yo_dt_b_asin_title_o05_s00?ie=UTF8&th=1 Specification: Material: stainless steel Output signal type: analog sensor Accuracy: 1% FS. Thread: G1/4 inch. Cable: Red: Power, Black: Earth, Green: Signal Approximate weight: 74 g. Power supply: 5V Signal: 0.54.5V/05V Output: 0-300PSI Raspberry PI 4 with following software installed: [login to view URL] Following software shall be used to collect the data from the pressure sensor: [login to view URL] Task 1: Write a Arduino IIDE programm which has following functionality: - Prepare connection diagram between NodeMCU and Pressure Sensor - Read the Voltage from the Pressure sensor - Convert Voltage to pressure Bar (0.5V = 0bar / 4.5V = 20.6843bar) - Connect NodeMCU to Wifi - Node MCU to start webserver and Display on web: => Voltage => Bar converted Presend => Bar last 10 readings average => Wifi Status => IP Address => SSID => Signal stregth => Device Name (shall be a variable in the program to allow multiple Arduinos in the system) Bar Value: - The bar value is the converted value from Volt to bar (see Specifications for PSI) - The pressure shall be read out 2 x / second. - The pressure (bar) send out to SignalK shall be the average of the past 10 readings. - The reading rate (readings / second) shall be adjustable by variable - The amount of data for the average shall be a variable and shall be adjustable NodeMCU to send the Bar pressure as above via UDP to Raspberry Pi / SignalK [login to view URL] I have a Raspberry PI freshly installed with the OpenPlotter (see [login to view URL]). It is connected to the Internet and Teamviewer installed. Raspberry PI & NodeMCU will be in the same WIFI network. Task 2: - Setup SignalK to receive the pressure data from NodeMCU through Wifi. IP for Raspberry Pi: Wifi: SSID: to follow Key: to dollow Password on Raspberry: User: pi Password: raspberry