Ardu-chute. 433mhz wireless ardu parachute

$30-250 USD

Terminado

Publicado

hace alrededor de 11 años

$30-250 USD

Pagado a la entrega

I want to make a R/C parachute system for my rc plane. Currently I have an arduino uno which has a push button on input A0 and this board sends out a serial value over a 433mhz tx from digital pin 2 I am recieving ok as watching the nano on the serial monitor it sees the change from 0 to 1023 when I press and hold the button down for a little bit I am very new to Arduino and have reached my current limits. So I seek your services and skills for what I would like to achieve below. UNO- is transmitter end. I want sketch which will only transmit a character command "popchute" once a push button has been pressed, I want a LED output to go LOW when the button is pressed. NANO- receiver end I want this to have 2 inputs as well as the recieved character command. input 1- push switch once pressed arms parachute system and will allow output IF input 2- is released (unpushed) (this happens once drone takes off/switch not making contact with the ground) If command is received and inputs 1 has been armed and input 2 has gone low I want 2 output pins made high. I hope this helps you see my vision?

Arduino

Electronics

Microcontroller

ID del proyecto: 4511994

Información sobre el proyecto

3 propuestas

Proyecto remoto

Activo hace 11 años

¿Buscas ganar dinero?

Dirección de email

Beneficios de presentar ofertas en Freelancer

Fija tu plazo y presupuesto

Cobra por tu trabajo

Describe tu propuesta

Es gratis registrarse y presentar ofertas en los trabajos

Adjudicado a:

@cbayanwala

I am currently working on my quadrotor, and have a good idea about these systems. Please check your pm for more details.

$55 USD en 15 días

0,0

(0 comentarios)

0,0

3 freelancers están ofertando un promedio de $90 USD por este trabajo

@betaenergy

Dear Sir, We are Reserach and Development company whose working area are : -Digital Motor Control -Analog Design -Electronic Design -Power Electronics -PCB design -Embedded system -Matlab -Simulation of hardware For each concept descriptions are as follows: Digital Motor Control: -3-phase induction motor vector control drive -Flux estimation algoritm generation -DSP(TMS320) implementation on motor drive -Low speed application -Torque and speed loop generation -Control algoritms Analog design -Low power distribution -Noissless special opamp based analog circuits -Analog filters -Orcad simulation of several circuits Electronic Design -RF transmitter and receiver -Bluetooh reader and transmitter -Magnetic reader Power Electronics -Implementation motor drive -AC/DC converter -DC-DC converter -Battery charger -Solar inverter -Renewable Energy simulations -Uninterruptle power supplies PCB design -Schematic design by Altium -PCB design by Altium -Power board design -SMPS board design Embedded system -PIC18,PIC24,PIC30 and dsPIC applications -Ardino -MSP430 -Atmel -DSP(Texas Instruments) -Renesas Matlab -Power Electronics simulation -Motor drive -Wind Energy -Solar Energy -Control applications Simulation of Hardware -Orcad Simulation(TI,National, Linear Tech, Maxim libraries) -LTI -National -Matlab Very important Note: References attached. Please look excel file to see projects which we made until now! Metin

$210 USD en 3 días