PLC stands for Programmable Logic Controller and it is a term used in automating electro-mechanical processes. SCADA is an abbreviation for supervisory control and data acquisition. It refers to industrial control systems where computers monitor or control a process. If your business needs help with PLC / SCADA then you can hire the help of talented PLC / SCADA freelancers on this site. Start by posting your job today. Contratar a PLC & SCADA Programmers

Filtro

Mis búsquedas recientes
Filtrar por:
Presupuesto
a
a
a
Tipo
Habilidades
Idiomas
    Estado del trabajo
    7 trabajados encontrados, precios en USD

    We would like a PLC to control a red, green traffic light system. using a Procon PL40 Programmable Logic Controller Loop Detector 220VAC and direction loop detection . so there will be one main controller ( master Station ) and a Slave controller to signal the master. we will have direction loops to signal the PLC ( slave station ) . PLC Program can be found: [iniciar sesión para ver U...

    $1025 (Avg Bid)
    $1025 Oferta Promedio
    8 ofertas
    Plc programming 6 días left
    VERIFICADO

    We would like to program a plc to control and monitor 4 sensor values with 24v DC outputs needed to be controlled

    $437 (Avg Bid)
    $437 Oferta Promedio
    7 ofertas

    I need to communicate with arduino using VISA read nand WRITE. I have alot of the code written. I just need someone to finish the communication so i can use PWM ports on ARDUINO using Visa read and WRITE

    $69 (Avg Bid)
    $69 Oferta Promedio
    12 ofertas

    We would like a PLC to control a red, green traffic light system. using a Procon PL40 Programmable Logic Controller Loop Detector 220VAC and direction loop detection . so there will be one main controller ( master Station ) and a Slave controller to signal the master. we will have direction loops to signal the PLC ( slave station ) . PLC Program can be found: [iniciar sesión para ver ...

    $959 (Avg Bid)
    Garantizado
    $959
    2 participaciones
    Plc programming 5 días left

    We would like to program a plc to control and monitor 4 sensor values with 24v DC outputs needed to be controlled

    $478 (Avg Bid)
    $478 Oferta Promedio
    44 ofertas

    We would like to get a PLC program to control multiple Danfoss FC51 VFD units (slaves) by Panasonic FP0R PLC unit (master) through Modbus RTU protocol (RS485) The software should be written on Panasonic software FP WinPro 7.

    $6 / hr (Avg Bid)
    $6 / hr Oferta Promedio
    13 ofertas

    Hello freelancers, I have a plant of packing and sorting. I wish to make automate my plant. More detail will be provided in message.

    $2762 (Avg Bid)
    $2762 Oferta Promedio
    14 ofertas