Design PCI device + FPGA PCI core
$300-1500 USD
Pagado a la entrega
I need a custom PCI module with the following requirements:
1) PCI interface is based on FPGA
2) FPGA PCI-target core is FREE of license
3) FPGA has SPI-master core
4) FPGA has TDM interface
5) FPGA with lowest price is required!
6) PCI device must have usual interface for OS (Linux in most) - BAR, DevID, VendorID etc
7) PCI device must have 3-5V interface
The structure of the PCI-card is a follows:
FPGA <-> Infineon DuSlic-SP chip
8 wires are the interface to DuSLIC:
a) 4 wires for SPI (CS, CLK, TX, RX)
b) 4 wired for TDM (FS, CLK, TX, RX)
Altera or Xilinx FPGAs are preferred, but not required. The lowest price is the main feature. No schematic for DuSLIC is in this project. Only PCI card + some connector for 8 wires. The PCB design for the card is not required. Schematic + FPGA core is required. The project is approved after a prototyping.
Nº del proyecto: #203136
Sobre el proyecto
8 freelancers están ofertando un promedio de $1069 por este trabajo
Hello! My name is Kirei Botond, I am a PhD student at the Technical University from Cluj Napoca, Romania. My area of expertize is FPGA bazed digital design. I am very familiar with Xilinx FPGAs and the design enviro Más
Dear Project Owner, We are in to embedded solutions since 1999 having 60 engineers working on this. We have already develop this type of application and also would like to develop for you. we have good experience Más
Please not down that Icant proveid any hardware/prototype. I can only provide design/codes etc
PCI expert here. Let me do it for you. Please check PM. No problem at all. We can start asap!
