Material handling system for 6 T capacity Box type reheating furnace

Cerrado Publicado hace 2 años Pagado a la entrega
Cerrado Pagado a la entrega

we need one material handling system to charge and discharge the product to forge inside the furnace .

material size 250 mm - 500 mm in diameter or any size as square / polygon / round etc.

length of the product is 500 mm to 3500 mm .

Ingeniería mecánica Ciencia de materiales Ingeniería Ingeniería química Ingeniería civil

Nº del proyecto: #30495880

Sobre el proyecto

4 propuestas Proyecto remoto Activo hace 2 años

4 freelancers están ofertando un promedio de ₹25000 por este trabajo

sajjadtaghvaeifr

Hi, I hope you are doing fine. I have PhD in mechanical engineering from Tohoku University of Japan. I have published 20 Journal papers and 16 international conference papers. I have a lot of experience in automotive, Más

₹25000 INR en 7 días
(45 comentarios)
6.0
harsh2609

Hello I have read your requirement and have some doubts about the same as it looks a little incomplete to me. It is highly dependent of the type of feed that you provide to the furnace. So you'll have to give informati Más

₹25000 INR en 7 días
(17 comentarios)
5.2
bahaa63

Hello dear, I am a Structural engineer. I am expert in structural analysis and design. I can finish your task in the required time. Please contact me to discuss the details and start working.

₹25000 INR en 7 días
(16 comentarios)
4.3
EmadAamer

I can complete the design of this project in time as demand Sincerely Emad Hamdu Mechanical Engineer

₹25000 INR en 7 días
(0 comentarios)
0.0