Microchip PIC32MX software
$250-750 USD
Pagado a la entrega
Hi,
I need some help by writing a microchip (PIC32MX470F512L) software with functionality according to the attached PDF.
I have a special made prototype board that will be supplied by me to the winning bidder.
The board have all parts soldered onto it, except the ESP wroom 02 module, that will need to be soldered into place by the winning bidder.
I want the code well commented, and developed in MPLAB X, and the winning bidder will need to have a programmer/debugger on his/her own.
As final verification I would like the bidder to present a film where a signal is transferred to the board and recieved by another device, connected to the ESP8266 unit.
Please let me know if you need more info.
Nº del proyecto: #13849716
Sobre el proyecto
18 freelancers están ofertando un promedio de $593 por este trabajo
Hi, I am a post graduate power electronics engineer and having very good experience in product design and development. I am excellent in embedded programming using pic, dspic controllers and MATLAB codding for Power p Más
Hello, I have a good expierence with PIC32 and other microcontrollers. I am using MPLAB X and Harmony. I have PIC32MX460/PIC32MZ2048 development boards and tools.
You need: - Soldering ESP module to your PCB - Develop firmware for PIC32MX470F512L in MPLABX as attached file. Basically functionalities are: + Control ESP over UART by AT command + Sampling ADC with Más
Hi, Can you please share your Compiler (XC32?) and complete Connection details(Schematics). About us: We have 10 years of experience in Product development. Micro-controllers we have worked on PIC, STM32, PSO Más
Hello sir i can help you with your project. However, i have some questions about your project. Send me a message and we could discuss in detail. Regards Carlos Maita
Hello, how are you? I hope you have a bright day/evening from your side. I have read the details provided, but please contact me so that we can discuss more on the project. I believe I have the required skills in this Más
Based on the pin assignment assuming the PIC 32 is 100-PIN TQFP, I will use below tools 1. MPLABX 2. PICKit 3 3. Solder the ESP wroom module Software task 1. Poll for connected device 2. Sample ADC signal Más