Develop a Labview sub VI to find maximum intensity in x-y plane

Cerrado Publicado Jun 23, 2015 Pagado a la entrega

$250-750 USD

Pagado a la entrega

Cerrado Pagado a la entrega

The sub VI I want to develop is for finding maximum intensity in x-y plane. Two stages are being used to locate a global maximum in x-y plane. The intensity profile is Gaussian with around 25 micron FWHM (full width half maximum). But the area where the Gaussian intensity profile is 4x4 mm. Therefore we need to find an effective way to find the maximum intensity as quick as possible instead of doing line scanning of the entire area. Please contact me if you are good at stage control and algorithm. Thank you in advance.

LabVIEW

Nº del proyecto: #7920230

Sobre el proyecto

7 propuestas Proyecto remoto Activo Jul 30, 2015

¿Quieres ganar algo de dinero?

Beneficios de ofertar en Freelancer

Establece tu presupuesto y plazo
Cobra por tu trabajo
Describe tu propuesta
Registrarse y ofertar en los trabajos es gratis

7 freelancers están ofertando un promedio de $431 por este trabajo

Foto de perfil de Nenad1526
Nenad1526

I am a Certified LabView Associated Developer (CLAD) with more than six years of experience working with LabView. I must say that I do not fully understand the requirements and therefore I would kindly ask you to send Más

$500 USD en 10 días
(65 comentarios)
6.6
Foto de perfil de m2otech
m2otech

Hi, I do not have specific experience with stage control but I have developed different kinds of algorithms in LabVIEW. If I understand the problem correctly we have a surface on which a maximum must be found. Besid Más

$500 USD en 15 días
(8 comentarios)
4.1
Foto de perfil de systronics23
systronics23

Hi I have more than 4 years of experience on LabVIEW. I have Implemented many algorithms. one of the latest was autofocus algorithm. Where the VI plots the SD of the Image(2000x2000 pixels) and finds the highest peak a Más

$444 USD en 10 días
(2 comentarios)
1.7
Foto de perfil de severick
severick

To whom it may concern: My name is Erick Vieyra, currently a currently employed engineer in a consulting firm in Västerås, Sweden. Many years of academic experience with LabVIEW, as well as the CLAD certification Más

$350 USD en 10 días
(0 comentarios)
0.0
Foto de perfil de yennamangad
yennamangad

I have programmed a lot of different devices (generators, power supplies, oscilloscopes, temp chambers, switch units, few data acquisition devices and special circuits) using different interfaces (GPIB, RS-232, TCP/IP, Más

$444 USD en 10 días
(0 comentarios)
0.0
Foto de perfil de anandtrivedi87
anandtrivedi87

I am an Electronics and Communication Engineer. A Certified LabVIEW Developer (CLD) with over 5 years of work experience in design, development and Commissioning of DAQ, ATE, and HIL test systems using NI-LabVIEW, Test Más

$333 USD en 5 días
(1 comentario)
0.0
Publicar un proyecto como este