I need a traffic light design with PIC, the circuit composite design (Proteus 8) and code (firmware) the traffic light to control up to 4-way, should be Programmable and also contain the pedestrian signaling LEDs, open (green) closed (red), the schedule of each route should be independent, the system must contain a button for the pedestrian push and request the passage, with regard to pedestrian time should exisitr two schedules, on a schedule LEDs Pedestrian must change from red to green automatically, ie after the complete cycle of the LEDs of the tracks, the pedestrian LEDs should change from red to green at given time. In manual mode, the time set for the pedestrian will only be activated (change from red to green) is the pedestrian button is pressed, then the pedestrian time +3 seconds as well be added to the red of the tracks, all programming must It is accomplished through 9 buttons (set, save, cancel, +, -, right, left, up, down) programming both LEDs
of roads as the pedestrian will be made through these keys and accompanied on the LCD when the system does not is in programming mode it should display the LEDs are driven at the time and the time to the next, that is, it should be in debug mode. I am available to answer questions, my budget is very limited, so take all the doubts to be no mistakes.
Hi, Greetings!
I am experienced and Qualified B. Sc Electrical Electronics Engineer with 5 years of experience in Embedded systems and Automation's (200 + Projects) .I have read your requirements and understand your project, I would like to discuss more about your project and start work immediately. For more You can view my resume by clicking https://www.freelancer.com/u/enggrsujad.html.
I am just a click away.
Have Good Day ahead.
Regards
Engr Sujad
I have full skill with PIC microcontroller.
I have also PROTEUS 8 simulation experience with top level.
If you want, I will send you my third project solution(Simple PIC....by CPFC13).
The solution consist of firmware that PIC do A/D conversion and record In EEPROM and send it to PC via UART, and its Proteus simulation file.
If you see this, you will confirm my ability.
Thanks.
I'm an Electrical Engineer in Communications and Electronics. I have experience in microcontrollers programming, including PIC and AVR. Additionally I have worked with arduino and raspberry-pi boards and have designed many PIC-based boards for solving specific industry tasks.
You should underdstand this is a large project, and that is why I am a little over your budget.
I hope I can help with this project
Best regards
Electric-Electronic Engineering student and ı am a member of a team who make electrical car.ı am using proteus 8 and CCS C. and ı am learning Altium Designer and arm programmer.I did a project like this for my friends ı can do it again :)
i have a good knowledge about PIC microcontroller programming and have done number of projects using PIC microcontroller from the last three year,i also work on proteus and have used for number of project.i will do your work easily and accurately.i will completes all the requirement you have mentioned,and a down counter is also display on the Lcd for each side along with the name (south,north,east,west) and so on.